Captured and Blind Glazed
Glazing gasket:
- Same EPM gasket used on exterior/interior and perimeter
Screw spline joinery allows:
- Panelized assembly for “Ladder” type installation
P-Bar:
- Factory pre-punched alignment holes 9” on center
- P-bar attached to back members with #12-14 x 1 ¼” HWH self -drilling screws
Removable snap-on interior trim cover at head, horizontal and sill allows:
- Direct head/sill attachment to substrate without using T-anchors
- Anchor inspection to substrate after glazing
- Through bolt attachment of panels for ease of installation and for high span wind loads
- Inspection of critical joinery seals after glazing and repair when necessary
Injection molded ABS plastic end dams at head, horizontal and sill allows:
- Tight seals at intersection of vertical/horizontal joints
- Zone glazed pressure equalized system for water control
- Water drains to exterior through weep holes located in pressure bar and face cap